Filter
Top Products
DTMF Playback Level Local DTMF playback level in dBm (up to 1
decimal place)
PwrLevel -10.0
DTMF Playback Length Local DTMF playback duration in ms Time3 .1
Detect ABCD Enable local detection of DTMF ABCD Bool Yes
Playback ABCD Enable local playback of OOB DTMF ABCD Bool Yes
Caller ID Method The following choices are available:
• Bellcore (N.Amer,China): CID, CIDCW,
and VMWI. FSK sent after 1st ring (same as
ETSI FSK sent after 1st ring) (no polarity
reversal or DTAS)
• DTMF (Finland,Sweden): CID only. DTMF
sent after polarity reversal (and no DTAS)
and before 1st ring
• DTMF (Denmark): CID only. DTMF sent
after polarity reversal (and no DTAS) and
before 1st ring
• ETSI DTMF: CID only. DTMF sent after
DTAS (and no polarity reversal) and before
1st ring
• ETSI DTMF With PR: CID only. DTMF sent
after polarity reversal and DTAS and before
1st ring
• ETSI DTMF After Ring: CID only. DTMF
sent after 1st ring (no polarity reversal or
DTAS)
• ETSI FSK: CID, CIDCW, and VMWI. FSK
sent after DTAS (but no polarity reversal) and
before 1st ring. Will wait for ACK from CPE
after DTAS for CIDCW.
• ETSI FSK With PR (UK): CID, CIDCW, and
VMWI. FSK is sent after polarity reversal and
DTAS and before 1st ring. Will wait for ACK
from CPE after DTAS for CIDCW. Polarity
reversal is applied only if equipment is on
hook.
Choice Bellcore
FXS Port Power Limit Options: 1, 2, 3, 4, 5, 6, 7, 8 Choice 3
Notes:
1. It should be noted that the choice of CID method will affect the following features:
• On Hook Caller ID Associated with Ringing – This type of Caller ID is used for incoming calls when
the attached phone is on hook. See figure below (a) – (c). All CID methods can be applied for this
type of caller-id
• On Hook Caller ID Not Associated with Ringing – This feature is used for send VMWI signal to the
phone to turn the message waiting light on and off (see Figure 1 (d) and (e)). This is available only for
FSK-based caller-id methods: “Bellcore”, “ETSI FSK”, and “ETSI FSK With PR”
• Off Hook Caller ID – This is used to delivery caller-id on incoming calls when the attached phone is
off hook. See figure below (f). This can be call waiting caller ID (CIDCW) or to notify the user that the
far end party identity has changed or updated (such as due to a call transfer). This is only available if
the caller-id method is one of “Bellcore”, “ETSI FSK”, or “ETSI FSK With PR”.
© 2004 Linksys Proprietary (See Copyright Notice on Page 2)
77