Filter
Top Products
• GPP_A through GPP_P
• GPP_SA through GPP_SD
Provision Enable:
ParName: Provision_Enable
Default: Enable
The CFG profile must be requested by the PHONE ADAPTER, and cannot be pushed from a
provisioning server (although a service provider can effectively push a profile by triggering the request
operation remotely via a SIP NOTIFY). The functionality is controlled by the Provision_Enable
parameter. The parameter enables the functionality encompassed by the remaining provisioning
parameters.
In addition, Provision_Enable also gates the ability to issue an explicit resync command from the web
interface (discussed earlier in the "Function URLs" section of this document).
Resync on Reset:
ParName: Resync_On_Reset
Default: Enable
Resync_On_Reset determines whether the PHONE ADAPTER will attempt to resync with the
provisioning server on power-up and following explicit reboot requests.
Resync Random Delay:
ParName: Resync_Random_Delay
Default: 2
Resync_Random_Delay helps to scatter resync requests from multiple devices uniformly over a
period of time, whose duration (in seconds) is indicated by this parameter. Hence, if a number of
PHONE ADAPTER devices were to power-up at the same time, their resync requests would be
distributed over time, lessening the impact on the provisioning servers.
Resync Periodic:
ParName: Resync_Periodic
Default: 3600
The PHONE ADAPTER attempts to resync with the provisioning server periodically, provided the
Resync_Periodic parameter is configured with a non-zero value. The value (in seconds) indicates the
interval between resync attempts. Normally, the PHONE ADAPTER will not start the resync while an
© 2004 Linksys Proprietary (See Copyright Notice on Page 2)
36