Filter
Top Products
• IVR can still be used on an SAS line, but the user needs to follow some simple steps: a) Connect a
phone to the port and make sure the phone is on-hook, b) power on the PHONE ADAPTER and c)
pick up handset and press * * * * to invoke IVR in the usual way. The idea behind this is that if the
PHONE ADAPTER boots up and finds that the SAS line is on-hook, it will not remove battery from the
line so that IVR may be used. But if the PHONE ADAPTER boots up and finds that the SAS line is
off-hook, it will remove battery from the line since no audio session is in progress.
• Set up the Proxy and Subscriber Information for the SAS Line as you normally would with a regular
user account.
• Call Forwarding, Call Screening, Call Blocking, DND, and Caller-ID Delivery features are not
available on an SAS line.
4.10.3. Per-Line Polarity Settings
Parameter Name Description Type Default
Idle Polarity Polarity before call connected {Forward,Reverse} Forward
Caller Conn Polarity Polarity after outbound call connected {Forward,Reverse} Reverse
Callee Conn Polarity Polarity after inbound call connected {Forward,Reverse} Reverse
4.10.4. Additional Timer Values (sec)
Parameter Name Description Type Default
Hook Flash Timer Min Minimum on-hook time before off-hook to
qualify as hook-flash. Less than this the on-
hook event is ignored. Range: 0.1 – 0.4 sec
Time3 0.1
Hook Flash Timer Max Maximum on-hook time before off-hook to
qualify as hook-flash. More than this the on-
hook event is treated as on-hook (no hook-
flash event). Range: 0.4 – 1.6 sec
Time3 0.9
Callee On Hook Delay The phone must be on-hook for at this time in
sec before the PHONE ADAPTER will tear
down the current inbound call. It does not apply
to outbound calls. Range: 0 – 255 sec
Time0 0
Reorder Delay Delay after far end hangs up before reorder
tone is played. 0 = plays immediately, inf =
never plays. Range: 0 – 255 sec
Time0 5
Call Back Expires Expiration time in sec of a call back activation.
Ragne: 0 – 65535 sec
Time0 1800
Call Back Retry Intvl Call back retry interval in sec. Range: 0 – 255
sec
Time0 30
Call Back Delay Delay after receiving the first SIP 18x response
before declaring the remote end is ringing. If a
busy response is received during this time, the
PHONE ADAPTER still considers the call as
failed and keeps on retrying.
Time3 0.5
VMWI Refresh Intvl Interval between VMWI refresh to the CPE Time3 0.5
Interdigit Long Timer
2
Long timeout between entering digits when
dialing. Range: 0 – 64 sec
Time0 10
Interdigit Short Timer
2
Short timeout between entering digits when
dialing. Range: 0 – 64 sec
Time0 3
© 2004 Linksys Proprietary (See Copyright Notice on Page 2)
75