Filter
Top Products
Log Resync Request
Msg
Syslog message generated when attempting
a resync
ProfileMsg See
provisioning
discussion
section
Log Resync Success
Msg
Syslog message generated after a
successful resync
ProfileMsg See
provisioning
discussion
section
Log Resync Failure
Msg
Syslog message generated after a failed
resync
ProfileMsg See
provisioning
discussion
section
GPP A thru GPP P General purpose parameter String empty
GPP SA thru GPP SD General purpose parameter String empty
Note: In a customized PHONE ADAPTER, the profile rule would point to a service provider’s server.
4.2.1. Firmware Upgrade
The PHONE ADAPTER is firmware upgradeable via TFTP and HTTP. Firmware loads are released
as single binary files, which contain all the modules pertaining to any one release version. By
convention, the firmware loads are named with the extension “.bin” (e.g. pap2.bin)
The PHONE ADAPTER can be configured to upgrade to a specific version, possibly staging through
intermediate releases, if necessary. This process can be automated for a pool of devices through
configuration profile parameters.
Alternatively, an individual PHONE ADAPTER can be directed to perform an upgrade to a specific
firmware load via its built-in web server interface (this mechanism is discussed in section 3.4.1 of this
document).
Firmware upgrades are attempted only when the PHONE ADAPTER is idle, since they trigger a
software reboot.
Firmware upgrades are controlled by the following parameters (which operate in a manner similar to
but independent of the provisioning parameters).
• Upgrade_Enable
• Upgrade_Error_Retry_Delay
• Upgrade_Rule
• Downgrade_Rev_Limit
• Log_Upgrade_Request_Msg
• Log_Upgrade_Success_Msg
• Log_Upgrade_Failure_Msg
Upgrade Enable:
ParName: Upgrade_Enable
Default: Enable
© 2004 Linksys Proprietary (See Copyright Notice on Page 2)
43