Filter
Top Products
active call is in progress. The PHONE ADAPTER will wait up to Forced_Update_Delay seconds for
both lines to become idle. If the adapter still is not idle, the adapter will perform a resync anyway.
Resync Error Retry Delay:
ParName: Resync_Error_Retry_Delay
Default: 3600
If a resync attempt fails, the PHONE ADAPTER will retry with a delay indicated by the
Resync_Error_Retry_Delay parameter, specified in seconds. If the value is zero, the PHONE
ADAPTER treats resync failures as though they were successful, and simply waits for the next
periodic event to resync.
Resync From SIP:
ParName: Resync_From_SIP
Default: Enable
Resync_From_SIP gates the ability of a service provider to trigger a profile resync via a SIP NOTIFY
message to the PHONE ADAPTER.
If the PHONE ADAPTER receives a SIP NOTIFY request with an Event header field value of
"resync", "reboot", or "restart"; the PHONE ADAPTER will attempt to Digest authenticate the notifier
using the authentication password used for registrations on that line if the Auth_Resync-Reboot
parameter is set. If this parameter is not set or if the NOTIFY request is authenticated, the PHONE
ADAPTER triggers a resync, cold-boot, or warm-boot respectively. The actual resync, reboot, or
restart will not take place until the PHONE ADAPTER is idle (i.e. no calls are in progress).
Profile Rule:
ParName: Profile_Rule
Default: /spa$PSN.cfg
ParName: Profile_Rule_B through Profile_Rule_D
Default: Empty
The Profile_Rule parameter is a script that identifies the provisioning server to contact when
performing a profile resync. The Profile_Rule_B, Profile_Rule_C, and Profile_Rule_D parameters are
also scripts used to contact other provisioning URLs. Each profile rule is executed only if the previous
profile rule was executed successfully(*).
© 2004 Linksys Proprietary (See Copyright Notice on Page 2)
37