Filter
Top Products
Contents
Issue 1.0 April 2006 57
2. At the command prompt, enter stop_vs.
The voice system stops.
3. Enter mirror_admin detach.
The system displays the following prompt:
Prompt for hard disk drive to detach
4. Type the number that corresponds to the hard disk drive to detach and press Enter.
The system detaches all submirrors from the failed hard disk drive.
5. Physically remove the failed hard disk drive.
For information on how to remove a disk drive, see the Sun Fire V210 and V240 Servers
Parts Replacement Manual or the Sun Fire 280R Server Service Manual. These
documents are available in Avaya IR System Help (under "Print documents") or from the
Sun Web site (http://www.sun.com).
When you are ready to install the replacement drive, see Activating disk mirroring for a new
hard disk drive on page 57.
Activating disk mirroring for a new hard disk drive
To activate disk mirroring for a new hard disk drive:
1. If you are not logged in, log in as root.
2. Enter stop_vs to stop the voice system.
3. Install a new hard disk drive that has the same geography and size as the drive that
failed.
For information on how to remove a disk drive, see the Sun Fire V210 and V240 Servers
Parts Replacement Manual or the Sun Fire 280R Server Service Manual. These
documents are available in Avaya IR System Help (under "Print documents") or from the
Sun Web site (http://www.sun.com).
4. Enter mirror_admin replace.
The new hard disk drive is partitioned and synchronized to the other hard disk. It takes
approximately 20 minutes for each 10 GB to copy data to the new hard disk.
For more information on this command, see mirror_admin command.