Filter
Top Products
ESTABLISHING NIGHT SERVICE
If your system has extra-alerting devices such as bells or flashing lights, you can use
them to provide Night Service for your business when the person who usually
answers calls is not on duty. Three extra-alerting devices can be connected to the
optional Services Module in the control unit to alert people to incoming calls. Follow-
ing the procedure below, you can assign individual lines to activate each of the extra-
alerting devices for Night Service. You can assign each line to only one extra-alerting
device.
1. If you have not already done so, enter administration mode by follow-
ing the boxed instructions on page 25.
2. Touch
Night Service.
The lights next to the administration mode buttons stop flashing, and the
green light next to
Night Service
remains on.
3. One by one, touch each line button to be covered by Night Service until
the green light beside the line button shows the appropriate code. Each
successive touch gives you one of the following codes:
Steady green on =
line activates alerting device 7
Flashing green =
line activates alerting device 2
Rapidly flashing green =
line activates alerting device 3
Green off
= line does not ring at an alerting device
4. Touch
Night Service.
The lights next to the administration mode buttons flash again.
5. Continue to administer your system, or leave administration mode by
following the boxed instructions on page 25.
Activating Night Service
To activate Night Service, the administrator/attendant console must be in the atten-
dant mode.
●
To turn on extra-alerting devices to announce incoming calls, press
Night Ser-
vice
on the attendant’s console.
The green light next to the button goes on.
●
To turn off the extra-alerting devices, press
Night Service.
The green light next to the button goes off.
56