Filter
Top Products
TEST
21-l 0
Configuration
Mamat
-
ports are idle.
lf
more than 32 ports are configured, the
VP 3lXldVP 300 makes
outcalls
when at least four ports are idle.
.
V
For AT&T System 75 integrations, all ports defmed as YES
are
used
for
outcalls,
with no restrictions
Enter YES or NO to enable or disable the VP
3OOs/VP
300’s selftest
rOUthe.
I'-
V
For
message waiting notification or alarm outcalls, multiple
calls cm be placed simultaneously. The Toshiba
VP
System
places only one network
outcall
at a time.
n Integration Cards
When configurmg the SIBTS Table for integration cards, the following information is
require&
CARD TYPE Enter the type of integration card
-
MlC.
INTEGRATION UNIT Enter the unit on the integration
card
being configured
-
1 or 2
LINE APPEARANCES
Enter 3 for Line
Appearance.
Enter the system port number or
range of port numbers assigned as line appearances
MESSAGE WAITING
UNK
Enter 1 or 2 for Message Waiting Link. Enter
Y@
or NO to specify
whether or not the
link
is to be used to light message waiting lamps.
DEFAULT
Enter YES or NO to specify which link is to perform system
message waiting notification for COS not specifically listed.
Currently, this field applies only to AT&T System
79Deftity
Gl
and AT&T System
8YDefmity
G2 integrations.
-..
cos
V
Speci@ only one link in the entire system as DEFAULT
Enter the Classes of Service for which the link is to perform
message waiting notification. Currently, this field applies only to
AT&T System
75IlIeftity
Gl
and AT&T System 85/Defmity G2
integrations
V
System Parameter 170
-
INTEGRATION ON/OFF LINK MUST
MATCH, must be set to YES, for the DEFAULT and COS
entries to take effect.
‘I