Filter
Top Products
Setup 127
3. Use the navigation key to highlight the Lock Phone option
of your choice.
4. Press to perform the function for the highlighted
option.
Important! If you change the NAM1 setting after setting the
phone to lock upon power-up and did not program a number
into NAM2, you won’t be able to access your phone. You
must call the Service Center to unlock your phone.
Change Lock
The default lock code is generally the last four digits of your
phone number. It is advisable to change the default lock code
to a secret code for security purposes.
1. In standby mode, press the left soft key ( )
Menu, then
press ,
for
Security. You’re prompted to enter
the lock code.
2. Press for Change Lock. You’re prompted to enter
the new lock code.
3. Enter the new lock code. You’re prompted to re-enter the
new lock code for verification.
4. Enter the new lock code again. Your changes are stored.
Your phone does not allow you to view the lock code for
obvious security reasons. If you change the lock code, be
sure to write down or memorize the new code.
Now
The phone locks immediately and stays locked
until you enter the lock code.
Option Function
MetroA610.book Page 127 Tuesday, July 6, 2004 3:12 PM