Filter
Top Products
17
Network Setup
Click the Network Setup item on the main menu; you will see the following web page.
1. LAN: You can change the LAN IP Address and Subnet Mask of the IPX-600 here. If there
is already another DHCP server or another NAT/Router device existed in the LAN network,
you must make sure that they are not using the same sub network.
2. WAN: You can configure the WAN IP as PPPoE, DHCP or static IP depending on the
internet connection method provided for the IPX-600 in the office.
3. NTP: To get the real time from internet, you need to choose the correct Time Zone of your
area. If the default NTP servers cannot work in your area, you have to find the workable
NTP servers and set the values in these fields. (In almost all cases, just use the default
NTP server and everything should be fine).
Figure 12. Network Setup page of IPX-600
DHCP Server
By clicking the DHCP Server page, you can configure the DHCP server of the IPX-600. You can
specify the DHCP Server IP Pool Start IP and DHCP Server IP Pool End IP.
IPX-600 could possibly get the DNS server from ISP (using PPPoE or DHCP), if you want this
DNS server information passed to DHCP client, you can check on Provide Real DNS Server option.
In the Dynamic DHCP Client List, you can see the active DHCP client lists.