Filter
Top Products
11
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Clock Setting
Date and Time
Make sure the handset is not being used.
1
Press (SNOOZE/ALARM).
•
“Set date & time” is displayed if the clock
has not been set yet.
2
Enter the year, month, day and time using
Ö, Ñ and á.
•
You can scroll to the desired number by pressing
Ö or Ñ. To move forward, press á.
To move backward, press Ü.
•If you enter a wrong year/month/day/time, move
to the desired field by pressing Ü or á, then
correct it by pressing Ö or Ñ.
•You can also enter the year, month, day and
time using the dialing buttons ((0) to (9)).
3
Select “AM” or “PM” by pressing Ö or Ñ.
•You can also press (*) to select “AM” or “PM”.
4
Press the soft key ( ).
•A beep sounds and the clock starts working.
•If 3 beeps sound, the setting is invalid. Start again from step 2.
•To exit the programming mode, press (SNOOZE/ALARM) or (OFF)
.
•You can exit the programming mode any time by pressing (SNOOZE/ALARM) or
(OFF)
.
•When entering the time using the dialing buttons, you cannot enter numbers
greater than 12. Do not use military time. (To set 13:00 hours, enter “0100”,
and select “PM”.)
To check the date and time
While the handset is not being used, press
(SNOOZE/ALARM).
•The date will be displayed above the time.
•The display will light for a few seconds. To make the
display stay lit with the handset on the charger while
not in use (standby mode), turn the LCD backlight
mode on (p. 20).
SAVE
Date:2002.08.10
Time:09:30 AM
IH
GF
=Date&Time
Charging
Set date & time
Date:2002.08.10
Time:09:30 PM
IH
GF
=Date
&Tim
e
SAVE
Date:2002.01.01
Time:12:00 AM
IH
GF
=Date&Time
SAVE
AUG.10
11
:
30AM
FUNCTION
ALARM
Ex. Aug. 10, 2002, 9:30
Ex. Handset on Charger