Filter
Top Products
79
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
Problem
The unit does not display
the caller’s name and/or
phone number.
The handset display exits
the Caller List.
You cannot page the
handset or base unit.
You cannot redial by
pressing
(PAUSE/REDIAL)
on the handset or
(REDIAL/PAUSE) on the
base unit
.
“Recharge battery” is
displayed, “” flashes
or the handset beeps
intermittently.
“Charge for 15HRS” and
“” are displayed and
the handset does not work.
You cannot answer a call
by lifting the handset off the
base unit or charger, or
pressing the dialing button
(
(0) to (9), (#) or (*)).
Cause & Remedy
•You need to subscribe to a Caller ID service.
•
Other telephone equipment may be interfering
with your phone. Disconnect it and try again.
•Other electrical appliances connected to the
same outlet may be interfering with the Caller
ID information.
•Telephone line noise may be affecting the
Caller ID information.
•The caller requested not to send his/her
information. See page 32.
•If a call is being transferred to you, the caller
information will not be displayed.
•Do not pause for over 60 seconds while
searching.
•
The called handset is too far from the base unit.
•The called unit is in use. Try again later.
•If more than 3 other users are using the
handsets and base unit, you may not be able
to page. Try again later.
•
If the last number dialed was more than 32 digits
long, the number will not be redialed correctly.
•The button has a double function as either
redial or pause. It will redial the last number
dialed if pressed at the outset of a call (p. 26,
29). If another number has been dialed first, it
will operate as a pause button (p. 63).
•Charge the battery fully (p. 14).
•The battery has been discharged. Charge the
battery fully (p. 14).
•When you set the line selection to “Line 1” or
“Line 2” and the call is being transferred to
you, press the relevant soft key ( or
) to answer the call.
LINE1
LINE2