Filter
Top Products
65
Advanced Operation
For assistance, please call: 1-800-211-PANA(7262)
Base unit
Make sure the base unit is not being used.
1
For line 1 ringer tone, press (RINGER!L1).
For line 2 ringer tone, press (RINGER!L2).
•The base unit rings at the current setting.
2
Within 5 seconds, select the desired ringer tone by pressing á or
Ü.
•Each time you press á or Ü, the ringer tone will change and ring.
•You can also select the ringer tone by pressing dialing buttons (1) to (6)
.
•You cannot change the ringer tone for internal calls.
Ringer Tone
You can select one of 6 ringer tones for each line from your handset or from
your base unit individually. When a call is being received on the line, the
handset and base unit ring in the selected tone.
LINE 1 is preset to “1”. LINE 2 is preset to “2”.
Handset
Make sure the handset is not being used.
1
Press (CONF/FUNCTION), and scroll to
“Ringer setting” by pressing Ö or Ñ,
and press á.
2
Scroll to “Ringer tone” by pressing Ö or
Ñ, and press á.
3
Press Ö (Line 1) or Ñ (Line 2) to select
the line.
•The line’s current setting will be displayed.
4
Select the desired ringer tone by pressing
Ö or Ñ.
•
Each time you press Ö or Ñ, the tone will
change and ring. If the ringer volume has been set
to OFF for the line, the handset will not ring (p. 21).
•You can also select the ringer tone by pressing dialing buttons (1) to (6).
5
Press the right soft key ( ).
•A beep sounds.
•To program the other line, start again from step 2.
•To exit the programming mode, press (OFF).
SAVE
Save directory
H
Ringer setting
Copy directory
Ringer volume
H
Ringer tone
Incoming call
Ringer tone
Line2 :2
GF
SAVE
LINE1 LINE2
Ringer tone
G
=Line1
F
=Line2