Filter
Top Products
19
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Line Mode
If the line is connected to a low voltage system such as a PBX, set to “B”.
Your phone comes from the factory set to “A”.
Make sure the base unit and the handset are not being used.
1
Press (CONF/FUNCTION).
2
Scroll to “Initial setting” by pressing
Ö or Ñ, and press á.
3
Scroll to “Set tel line” by pressing Ö
or Ñ, and press á.
4
Scroll to “Set line mode” by pressing Ö
or Ñ, and press á.
5
Press Ö (Line 1) or Ñ (Line 2) to select
the line.
•The line’s current setting will be displayed.
6
Select “B” or “A” by pressing Ö or Ñ.
7
Press the right soft key ( ).
•A beep sounds.
•To program the other line, start again from step 4.
•To exit the programming mode, press (OFF).
•You can exit the programming mode any time by pressing (OFF).
SAVE
Set line mode
Line1 :B
GF
Set line mode
Line1 :B
Set flash time
H
Set line mode
---------------
Caller ID edit
H
Set tel line
Voice mail
---------------
H
Save directory
Ringer setting
Copy directory
H
Initial setting
2Way radio mode
Set line mode
G
=Line1
F
=Line2
SAVELINE1 LINE2