Filter
Top Products
To erase the password on the base unit (when you cannot use the handset):
If you cannot remember the password,
you can retrieve messages from Mailbox
2 or 3 after erasing the password on the
base unit. Please note that the following
setting will return to the factory preset
with the password.
1. Press (PROGRAM).
2. Press (MUTE).
3. Enter (#)(9)(0)(0)(0).
66
Mailbox Features
•If you do not want the unit to answer calls, press (ANSWER!ON) again to turn off
the Answering System. The indicator light goes out and “Answer off” is heard.
•
You can also turn on the Answering System remotely using any other phone (p. 78).
•If you turn the Answering System on with “” flashing, “” will disappear but
the clock is still incorrect. Adjust the date and time (p. 21). If you subscribe to a
Caller ID service (p. 34), the caller ID information will adjust the clock.
Monitoring incoming calls
While a call is being recorded, you can monitor it through the base unit speaker.
•To increase the speaker volume, press Ñ. To decrease, press Ö.
To answer the call with the base unit speakerphone, press (DIGITAL!SP-PHONE).
For the handset, press or . The unit stops recording.
Automatic Answering Operation
The Answering System allows the unit to answer calls with a greeting
message. Callers can then leave a message in a mailbox (p. 64).
Setting the Unit to Answer Calls
Press (ANSWER!ON) to turn on the
Answering System.
•The indicator lights and the unit announces
“Answer set” and the current day and time.
•The unit will announce the remaining
recording time if it is less than 5 minutes.
•If you hear “Memory full”, “” is displayed
on the base unit and the ANSWER ON
indicator flashes rapidly, erase some, or all, of
the messages (p. 68).
FULL
(ANSWERÒON)
and Indicator
Function
Dialing mode
Flash time
Line mode
Number of rings
Recording time
Remote code
Base unit Incoming
Call Tone
Base unit Room
Monitor mode
Factory preset
Tone
700ms
A mode
4
3 min.
11
2
off