Filter
Top Products
65
Answering System
For assistance, please call: 1-800-211-PANA(7262)
Setting the Mailbox Password (for Mailbox 2 and 3)
You can use Mailbox 2 or 3 for your personal mailbox, and prevent unauthorized
people from accessing the mailbox and listening to the messages. Assign 2-digit
password (00–99) to Mailbox 2 or 3. Each password and the remote code (p. 75)
must be unique. Once the password is assigned to Mailbox 2 or 3, no one can
access the mailbox to listen to messages without entering the password.
Make sure the base unit and the handset are not being used.
1
Press (CONF/FUNCTION), and scroll to
“Initial setting” by pressing Ö or
Ñ, and press á.
2
Scroll to “Set answering” by pressing Ö
or Ñ, and press á.
3
Scroll to “Set
mailbox2&3
” by pressing
Ö or Ñ.
4
Press á.
5
Select the mailbox by pressing Ñ
(Mailbox 2) or Ö (Mailbox 3).
•If the password has already been assigned to
the mailbox, it is displayed.
6
Enter a password using a 2-digit number
(00–99).
•If you entered a wrong number, press
(HOLD/CLEAR) and enter the password again.
7
Press the right soft key ( ).
•A beep sounds.
•If 3 beeps sound, you entered the same password as the other mailbox or
the remote code (p. 75) or the entered password was one-digit. Start again
from step 6 and select another password.
•To exit the programming mode, press (OFF).
To check the password: Repeat steps 1 to 5.
•The password is displayed. When finished, press
(OFF)
.
To erase the password
Press (HOLD/CLEAR) in step 6, and press the right soft key ( ).
•You will be able to access the mailbox without entering the password.
SAVE
SAVE
Set password
Mailbox2 :--
SAVE
Set password
F
=Mailbox2
G
=Mailbox3
Set password
Mailbox2 :22
SAVE
Copy directory
H
Initial setting
2Way radio mode
Remote code
H
Set mailbox2&3
---------------
Set tel line
H
Set answering
Set base unit