Filter
Top Products
Make sure the base unit and the handset are not being used.
1
Press (CONF/FUNCTION).
2
Scroll to “Date and time” by pressing Ö
or Ñ.
3
Press á.
4
#Enter the year, and month and day using
4-digit numbers. (Ex. To set Apr. 7, 2002,
enter “2002” and “0407”.)
$Enter the time (hour and minute) using
a 4-digit number. (Ex. To set 9:30, enter “0930”.)
•If you enter a wrong number, press Ü or á to move the cursor to the
incorrect number. Enter the correct number.
5
Select “AM” or “PM” by pressing (*).
6
Press the right soft key ( ).
•A beep sounds and the clock starts working.
•If 3 beeps sound, the setting is not correct. Start again from step 4.
•To exit the programming mode, press (OFF)
.
•You can exit the programming mode any time by pressing (OFF).
•When entering the time in step 4, you cannot enter numbers greater than 12.
Do not use military time. (To set 13:00 hours, enter “0100”, and select “PM” by
pressing (*).)
SAVE
Preparing the Answering System
21
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Date and Time
Voice Day/Time Stamp: During playback, a synthesized voice will
announce the day and time that each message was recorded.
SAVE
Ringer setting
H
Date and time
Copy directory
Date:2002.04.07
Time:09:30 PM
IH
0-9=Date&Time
=AM/PM
SAVE
Date:2002.04.07
Time:09:30 AM
IH
0-9=Date&Time
=AM/PM
SAVE
If a power failure occurs, the time may be shifted. When “” flashes on the
base unit display, adjust the date/time.
To check the date/time
Repeat steps 1 to 3.
•The date and time will be displayed. When finished, press (OFF).
Date:2002.01.01
Time:12:00 AM
IH
0-9=Date&Time
=AM/PM