Filter
Top Products
63
Cordless Telephone
For assistance, please call: 1-800-211-PANA(7262)
Incoming Call Tone
During an intercom call (p. 49) or while using the Room Monitor feature
(p. 56) or while listening to messages (p. 67, 71), you can be informed by
two tones if a call arrives. If you set to ON, this incoming call tone will be
heard for as long as the line rings. To delete the incoming call tone, set to
OFF. To set the incoming call tone to sound twice, set to “2”. Both the
handset and base unit are preset to “2”.
Handset incoming call tone
Make sure the handset is not being used.
1
Press (CONF/FUNCTION).
2
Scroll to “Ringer setting” by pressing
Ö or Ñ, and press á.
3
Scroll to “Incoming call” by pressing Ö
or Ñ, and press á.
•The current setting will be displayed.
4
Select the desired setting, “On”, “Off” or
“2”, by pressing Ö or Ñ.
5
Press the right soft key ( ).
•A beep sounds.
•To exit the programming mode, press (OFF).
Base unit incoming call tone
Use the handset. Make sure the base unit and the handset are not
being used.
1
Press (CONF/FUNCTION), and scroll to “Initial setting” by
pressing Ö or Ñ, and press á.
2
Scroll to “Set base unit” by pressing Ö
or Ñ, and press á.
3
Press á at “Incoming call”.
•The current setting will be displayed.
4
Select the desired setting, “On”, “Off” or “2”,
by pressing Ö or Ñ.
5
Press the right soft key ( ).
•A beep sounds.
•To exit the programming mode, press (OFF).
SAVE
SAVE
Save directory
H
Ringer setting
Date and time
Ringer tone
H
Incoming call
---------------
Incoming call
Incomin
tone :2
GF
SAVE
Set answering
H
Set base unit
Registration
---------------
H
Incoming call
Room monitor
Incoming call
Incomin
tone :2
GF
SAVE