Filter
Top Products
WLAN specific configuration 181
ATTENTION
2.x code is not supported. Nortel recommends that sites upgrade to 3.2.116.21
code. Contact Nortel GNTS Technical support to obtain this code—do not
download it from the Cisco Web site.
Specific Cisco configuration examples
Table 22 "1230 connected with 2950 and 2245 connected with 2950" (page
181) provides the steps to configure the Cisco Aironet 1230 connected
with a Cisco Catalyst 2950, and the WLAN IP Telephony Manager 2245
connected with the Cisco Catalyst 2950.
Table 22
1230 connected with 2950 and 2245 connected with 2950
AP: 1230 2950 connected the APs 2950 connected to 2245
1
class-map match-all
class_SVP_VoIP
match ip protocol 119
(protocol 119 marked
the value of cos 5)
mls qos map cos-dscp 0 8 16
40 32 46 48 56
mls qos map cos-dscp 0 8 16 40
32 46 48 56
2
Policy-map
wireless-SVP-VoIP
class class_SVP_VoIP
wrr-queue bandwidth 25 25 50
0
wrr-queue cos-map 1 0 1 2 4
wrr-queue cos-map 3 3 6 7
wrr-queue cos-map 4 5
(dscp 40 and 47 by default are
marked as cos 5)
wrr-queue bandwidth 25 25 50 0
wrr-queue cos-map 1 0 1 2 4
wrr-queue cos-map 3 3 6 7
wrr-queue cos-map 4 5
(dscp 40 and 47 by default are
marked as cos 5)
3
int fastethernet 0.240
encapsulation dot1Q
240 service-policy input
wireless- SVP-VoIP
int fastethernet 026 (the port
that is connected with the AP)
switchport trunk native vlan 11
switchport trunk allowed vlan
11, 240
switchport mode trunk
mls qos trust cos
int fastethernet 03 (the port that
connected with 2245)
switchport access vlan xx
switchport mode access
mls qos trust cos
mls qos cos 5
service-policy input
trust-voice-2245
4
(for return path) dot11
priority-map avvid
class-map match-all voice-sig
match access-group 100
5
access-list 100 permit udp
172.23.0.016 eq 5000
172.23.0.016
6
class-map match-all
voice-bearer match
access-group 101
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
Copyright © 2004-2007, Nortel Networks
.