Filter
Top Products
160 Appendix A WLAN Application Gateway 2246
Figure 28
WLAN Application Gateway 2246 connection to Application Server through a modem
Continuing configuration through Telnet
After the IP address for the WLAN Application Gateway 2246 is configured,
the WLAN Application Gateway 2246 reset and connected to the LAN
and the Application Server, Telnet can be used to continue the WLAN
Application Gateway 2246 configuration.
Connecting through Telnet
Connection to the WLAN Application Gateway 2246 can be done through
the network using Telnet. Telnet can only be used after the WLAN
Application Gateway 2246 IP address is configured.
The Telnet method of connection is used for routine maintenance of the
system for both local and remote administration, depending on the network.
Follow the steps in Procedure 18 "Connecting to a WLAN Application
Gateway 2246 through Telnet" (page 160) to connect to a WLAN Application
Gateway 2246 through Telnet.
Procedure 18
Connecting to a WLAN Application Gateway 2246 through Telnet
Step Action
1
Run a Telnet session to the IP address of the WLAN Application
Gateway 2246.
2
Log in to the WLAN Application Gateway 2246.
The NetLink OAI System screen appears.
Note: Because the WLAN Application Gateway 2246 is initially
configured, the NetLink OAI System screen now has some
different options displayed.
—End—
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
Copyright © 2004-2007, Nortel Networks
.