Filter
Top Products
Dropped calls 131
Message Description Action
Erase Failed Download process failed to
erase the memory in the
wireless handset.
Operation retries but can
eventually report the error int.
error: 0F.
Power cycle the wireless
handset.
Erasing memory The wireless handset has
determined that a download
must occur and is erasing the
current software from memory.
None. When the progress bar
fills the display line, the erase
operation is complete.
Note: Do not turn the handset
off during this operation.
Error!
[error details]
(For the WLAN Handset
6120/6140 only)
A fatal software error is
detected. All handset operation
is halted and any call is lost.
This message appears during
the Halt on Error mode. To
capture the error message,
reboot the handset and write
down the information that is on
the display.
Files Too Big The handset software
download files are incorrect or
corrupted.
Download new software from
the Nortel site.
See "Updating software" (page
114).
Flash Config Error Handset internal configuration
is corrupt.
Perform the Restore
Defaults operation from
the administrator menu and
reprogram, or reprogram using
the Configuration Cradle.
Initializing The wireless handset is
performing a power-on
initialization.
None. This is informational
only.
Internal Err. # # The wireless handset has
detected a fault from which it
cannot recover.
OE=Error while writing the
Flash (return handset to
factory)
OF = No functional code
(contact Nortel Technical
Support)
Record the error code so it can
be reported. Turn the wireless
handset off, and then on
again. If the error persists, try
registering a different wireless
handset to this telephone port.
If the error still persists, contact
Nortel Technical Support and
report the error.
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
Copyright © 2004-2007, Nortel Networks
.