Filter
Top Products
152 Appendix A WLAN Application Gateway 2246
Procedure 13
Installing the WLAN Application Gateway 2246
Step Action
1
Place the WLAN Application Gateway 2246 on a shelf or convenient
location.
Note: The WLAN Application Gateway 2246 is physically
connected to the Ethernet switch and can be placed in any
convenient location within 325 ft (100 m) of the switch. It can
also be rack-mounted.
2
Connect the power plug from the WLAN Application Gateway 2246
power adapter to the power jack on the front (or rear) of the box.
ATTENTION
IMPORTANT
Use only the power adapter provided by Nortel.
3
Plug the power adapter into an outlet or outlet strip.
4
Apply power to the WLAN Application Gateway 2246.
5
Ensure that the ERROR LED is off and LED 1 is blinking.
—End—
Configuring the WLAN Application Gateway 2246 IP address
You must connect to the WLAN Application Gateway 2246 through a serial
connection to configure the IP address and the network parameters. After
this is done, you can perform administration and further configuration
through a Telnet connection using the Administration Console.
Follow the steps in Procedure 14 "Connecting to the WLAN Application
Gateway 2246 through a serial port" (page 152) to make a serial connection
to the WLAN Application Gateway 2246.
Procedure 14
Connecting to the WLAN Application Gateway 2246 through a serial port
Step Action
1
Using a DB-9 female, null-modem cable, connect the WLAN
Application Gateway 2246 to the serial port of a terminal or PC.
2
Run a terminal emulation program (such as HyperTerminal) or use a
VT-100 terminal with the following configuration:
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
Copyright © 2004-2007, Nortel Networks
.