Filter
Top Products
Linksys SPA9x2 Phone Administration Guide Cisco Confidential--First Draft143
Regional Tab
SPA9x2 Phone Field Reference
SIT3 Tone Alternative to the Reorder Tone played when an error
occurs as a caller makes an outbound call. The RSC to
trigger this tone is configurable on the SIP screen.
Defaults to 914@-16,1371@-16,1777@-16;20(.380/0/
1,.380/0/2,.380/0/3,0/4/0)
SIT4 Tone This is an alternative to the Reorder Tone played when
an error occurs as a caller makes an outbound call. The
RSC to trigger this tone is configurable on the SIP screen.
Defaults to 985@-16,1371@-16,1777@-16;20(.380/0/
1,.274/0/2,.380/0/3,0/4/0).
MWI Dial Tone Played instead of the Dial Tone when there are unheard
messages in the caller’s mailbox.
Defaults to 350@-19,440@-19;2(.1/.1/1+2);10(*/0/1+2).
Cfwd Dial Tone Played when all calls are forwarded.
Defaults to 350@-19,440@-19;2(.2/.2/1+2);10(*/0/1+2).
Holding Tone Informs the local caller that the far end has placed the
call on hold.
Defaults to 600@-19*(.1/.1/1,.1/.1/1,.1/9.5/1).
Conference Tone Played to all parties when a three-way conference call is
in progress.
Defaults to 350@-19;20(.1/.1/1,.1/9.7/1).
Secure Call Indication Tone Played when a call has been successfully switched to
secure mode. It should be played only for a short while
(less than 30 seconds) and at a reduced level (less than -
19 dBm) so it does not interfere with the conversation.
Defaults to 397@-19,507@-19;15(0/2/0,.2/.1/1,.1/2.1/2).
Page Tone Specifies the tone transmitted when the paging feature
is enabled.
Defaults to 600@-16;.3(.05/0.05/1).
Alert Tone Played when an alert occurs.
Defaults to 600@-19;.2(.05/0.05/1).
Parameter
Description