Filter
Top Products
Default Settings Quick Reference Guide
133
Table 38 Universal Monitor - other default settings
JUMPER SETTINGS
Feature Default Other Options
Digital output loss-of-power jumpers OFF - Normally Open ON - Normally Closed
Note: Jumper position has no effect when the Universal Monitor has power.
12VDC/24VDC analog input jumper 24VDC Acceptable voltage for all four two-wire analog sensors
P20 jumper
Not jumpered (not
connected)
—
422 TERM jumper
Default: jumpered
(connected)
—
485 TERM jumper
Default: jumpered
(connected)
—
Audible horn Enabled May be disabled via the audible horn jumper
Manual Override switch
Off (outputs controlled by
programming)
On (Turn on all output relays)
DEFAULT SETTINGS - MODEM (FROM TABLE 27)
Feature Default Other Options
Initialization String (Init String) ATS0=1
Any string (up to 40 characters); for international
dialing, add +GCI=xx, where xx is the country code
(except B5 countries—see Table 27)
Enable Modem Diagnostic Messages N (disable) Y (enable)
Modem Dial Prefix ATE0X4DT Any string
Modem Hang Up Delay After a Call 10 seconds Any number (up to 99 seconds)
DIP SWITCH SETTINGS
Feature Default Other Options
8-position DIP switch All are OFF (down)
May be used to reset password to factory default (see
9.9.1 - Change Password)
OTHER SETTINGS
Feature Default Other Options
Change state of outputs - automatic
or manual control
AUTO (automatic control)
Force an output ON / OFF via Manual Output Ctrl menu
Force all outputs ON via hardware switch
Password AAAA Any 4 characters (see Table 20 for valid characters)
Reset common alarm with silence N (not reset) Y (reset with silence)
Battery connected Y (connected) N (not connected)