Filter
Top Products
P A Y C L O C K U S E R ’ S G U I D E
11
The computer will automatically begin installation of the
required software drivers. Follow these instructions to
successfully complete the installation of the software drivers.
Windows XP - Install the USB Drivers
These two software drivers must be installed for the PayClock USB
terminal to operate properly: TUSB2136 Firmware Loader and
Lathem TouchStation LCD/LED USB Device.
NOTE about USB terminals using a Finger Sensor
A third driver (U.areU. 4000B) will load automatically if the PayClock
USB terminal has a fingerprint reader.
Two separate “Found New Hardware Wizards” will appear in
succession. You must complete both Wizards. Please note that it
may take up to one minute for each Wizard to automatically appear.
Please be patient.
After successfully connecting the PayClock USB terminal to
your computer the message, “Found New Hardware” will
show in the Notification Area with the USB icon .
The “Found New Hardware Wizard” will display. Select
“No, not this time” and click “Next >”.
Note:
Up to 1
minute may
pass before
the message
displays,
please be
patient.