Filter
Top Products
46
english
Jabra PRO 9460, Jabra PRO 9460 DUO, Jabra PRO 9465 DUO AND Jabra PRO 9470 USER MANUAL
How to replace the battery
If you begin to notice that you get significantly less talk time between battery charges, it might be time to replace
the battery.
To replace the headset battery:
1. Order a Jabra PRO battery-replacement kit from Jabra (contact your Jabra representative or see our web site
for details).
2. Remove the wearing-style attachment from your headset (see also Section 7.2: Attaching or detaching a
Wearing Style).
3. Place the headset down on a table with the speaker facing up.
4. Use the screwdriver supplied with the battery-replacement kit to remove the three screws indicated in the
figure below.
5. Carefully tilt the speaker plate up, allowing it to rotate around the edge where the boom arm sticks out.
6. The battery is the rectangular component now visible in the center of the headset body. Gently pry the battery
up and out of the headset. The battery will remain attached to the headset by a pair of very thin wires.
7. Grab the two wires that connect the old battery to the headset and gently pull them straight away from the
socket inside the headset until they are free.
8. Align the wired connector for your new battery with the socket inside the headset and press it all the way in.
If you have trouble, you might have the connector upside down — try the other way.
9. Fold the wires beside the new battery in the wire groove and press the battery down into place in the
headset. Ensure that the battery label faces upwards for the correct orientation.
10. Replace the speaker plate and insert and tighten each of the three screws you removed at the start of this
procedure.