Filter
Top Products
40
english
Jabra PRO 9460, Jabra PRO 9460 DUO, Jabra PRO 9465 DUO AND Jabra PRO 9470 USER MANUAL
R
L
Figure 46: Adjusting the ear hook
4. Take off the ear hook assembly.
5. Align the mounting surface of the headset with the matching socket on the ear-hook attachment. Press the
headset assembly firmly onto the outer side of the attachment until it clicks into place (snap-to-click). Refer to
the figure in the section 4.3: “Assemble the Headset” earlier in this manual.
6. Turn the headset in the socket to ensure that it is mounted correctly.
7. Put on the ear hook and headset assembly.
8. Turn the headset boom arm so that the microphone is right in front of the corner of your mouth.
See also Section 7.1: How to Wear the Headset for illustrations.
Detaching the ear hook
1. Hold the headset in one hand and turn the whole assembly to find the one slot on the ear-hook attachment
socket that is larger than the others.
2. Apply your thumbnail to the slot and pull the entire ear hook assembly away from the headset.
Attaching the neckband
1. Decide whether you want to wear the neckband on the left or right ear — you might need to pull out the
neckband itself from the ear-cushion attachment, rotate the attachment 180 degrees and then push the other
end of the band back in to change left/right orientation. Left and right assemblies are shown below:
Figure 47: Neckband ready for wearing on the left and right ears
Each end of the neckband has a slot. This slot must be aligned with the notch inside the loop of the ear-cushion
attachment when you insert the band.
2. Align the mounting surface of the headset with the matching socket on the ear-cushion attachment. Press
the headset assembly firmly onto the outer side of the attachment until it clicks into place (snap-to-click).
Refer to the figure in the section 4.3: “Assemble the Headset” earlier in this manual. If you have trouble pressing
them together, try to rotate the boom arm about 30 and try again.