Filter
Top Products
ADDENDUM TO ISSUE 4 OF THE AXXESS MANUALOCTOBER 1997
Page 66 of 73
Canadian Information
The AXXESS System has been tested and certified for
installation in Canada. Following is a list of Industry
Canada regulations which are similar to the FCC regu-
lations already included in the manual.
INDUSTRY CANADA REGULATIONS
NOTICE: The Industry Canada label identifies certi-
fied equipment. This certification means that the equip-
ment meets certain telecommunications network
protective, operational, and safety requirements as pre-
scribed in the appropriate Terminal Equipment Techni-
cal Requirements document(s). It does not guarantee
the equipment will operate to the user’s satisfaction.
1. Before installing this equipment, users should en-
sure that it is permissible to be connected to the
facilities of the local telecommunications company.
The equipment must also be installed using an
acceptable method of connection. The customer
should be aware that compliance with the above
conditions may not prevent degradation of service
in some situations.
2. Repairs to certified equipment should be coordi-
nated by a representative designated by the suppli-
er. Any repairs or alterations made by the user to
this equipment, or equipment malfunctions, may
give the telecommunications company cause to re-
quest the user to disconnect the equipment.
3. Users should ensure for their own protection that
the electrical ground connections of the power util-
ity, telephone lines and internal metallic water pipe
system, if present, are connected together. This pre-
caution may be particularly important in ruralareas.
CAUTION: Users should not attempt to make such
connections themselves, but should contact the
appropriate electric inspection authority, or electri-
cian, as appropriate.
4. The Ringer Equivalence Number (REN) of this
device is:
1.1
NOTICE: The REN assigned to each terminal de-
vice provides an indication of the maximum num-
ber of terminals allowed to be connected to a tele-
phone interface. The termination on an interface
may consist of any combination of devices subject
only to the requirement that the sum of the Ringer
Equivalence Numbers of all the devices does not
exceed 5.
5. The standard connecting arrangement codes for this
equipment are:
CA11A
CA21A
CA81A
CA48C