Filter
Top Products
ADDENDUM TO ISSUE 4 OF THE AXXESS MANUALOCTOBER 1997
Page 64 of 73
←
NEW FLAG
“Forced Delayed Major Reset” System
Flag
As shown above, a new “Forced Delayed Major Reset”
flag was added to the System Flags screen.
Normally, the system will not perform a major reset if
there are any active calls. However, if this flag is en-
abled, the system will force a major reset at a specified
time. The time is either the default delayed major time
or the user-specified delayed major time programmed
in the Miscellaneous System-Wide Information screen.
The default for this flag is “Disabled.”
The major reset will cause all active calls on the system
to be dropped. Because of this, the flag should be used
only on systems which run on a 24-hour basis and do
not have a consistent time, when all resources are idle,
during which a normal delayed major reset can be per-
formed.
This flag affects any request to perform a major reset,
whether it be by the system itself for resource reconcili-
ation, or requested by the programmer through the Da-
tabase Save/Restore screen, Reset System command.
NOTE: If this flag is enabled, the installer should in-
form the customer that enabling this flag will drop all
active calls at the specified delayed major time, should
a major reset be necessary. This will not happen every
day, but it will happen occasionally. The customers
should be aware of this so that they do not mistake the
reset for a system failure.