Filter
Top Products
47
Cisco Unity Express 8.0 Voicemail User’s Guide for Advanced Features
OL-23857-01
Administering Broadcast Messages
Sending Broadcast Messages to Select Locations
Note Not all menu items are valid for all users. If you receive a “Networking messaging is disabled” message,
this feature is disabled.
To record and send a broadcast message to select locations:
Step 1 Perform the steps in the “Logging In To VoiceView Express” section on page 33 to display the Personal
Mailbox menu.
Step 2 From the Personal Mailbox menu, choose Administer Broadcast Msgs and press Select. The Send
Broadcast Messages menu appears.
Step 3 Choose Select Locations.
Step 4 Address message by location ID number or (optionally) press Name, then:
• To address by location ID, use the dial pad to enter the exact location ID number.
• To address by location name, use the dial pad to enter the location name or partial location name to
search for matching names. Each key represents one or more characters. Continue to rapidly press
the key to select the desired letter from the menu.
Step 5 Press Submit. The Matching Address menu appears.
Step 6 Choose the desired address and press Add to build a recipient list.
Step 7 After adding an address, press any of the following soft keys:
• AddMore—Return to Address by Number window and add another address to the recipient list.
• Remove—Remove address from list. You cannot empty the list by removing the only recipient.
• Cancel—Cancel operation.
• Record—Switch on the microphone and begin recording. Say your message, then press Stop. To
cancel recording, press Stop immediately, then press Cancel.
Step 8 After recording the message, review start and end time for the broadcast message. Press Cancel to cancel
the message or press OK to display the Send Broadcast Message menu.
Step 9 To send the message immediately, press Send; otherwise, choose one of the following and press Select.
• Listen to Recorded Message—Play message to be sent.
• Record Again—Switch on the microphone and begin recording. Say your message, then press Stop.
• Edit Recipients—Return to Recipient List menu where you can add or remove recipients.
• Review Start & Stop Time—Display window, then press Cancel to cancel the message or press
OK to accept the start and end time for the broadcast message.
• Set Start Time—Display the Set Start Time menu. See the “Specifying Start or End Time” section
on page 48 to modify the start time.
• Set End Time—Display the Set End Time menu. See the “Specifying Start or End Time” section on
page 48 to modify the end time.