Filter
Top Products
5-14
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)
OL-4803-01
Chapter 5 Parameters and Defaults
MGCP Configuration Parameters
CA1UID
Description
Specify the ID of the secondary Call Agent in this parameter.
Value Type
Alphanumeric string
Range
Maximum 31 characters
EPID0orSID0 and EPID1orSID1
Description
EPIDx (for MGCP only) specifies the alphanumeric Endpoint Identifier assigned to line x of the
Cisco ATA, where x=0 or 1. The complete Endpoint Identifier sent to the Call Agent has the format
<EPIDx>@<ip_addr>. (SIDx does not apply to MGCP.) To enable the usage of square brackets around
the IP address of the endpoint, enable Bit 20 of the ConnectMode parameter. (See the “ConnectMode”
section on page 5-24.)
Note Setting the EPID0orSID0 or EPID1orSID1 parameter to 0 does not disable the respective line.
Value Types
Alphanumeric string for each parameter
Default
.—The dot is the default and means that the value of aaln/1 is used as the MGCP endpoint ID for EPID1
and aaln/2 is used as the MGCP endpoint name for EPID2.
Range
Maximum 51 characters for each parameter
Voice Configuration Menu Access Codes
46 and 47 for EPID0orSID0 and EPID1orSID1, respectively