Filter
Top Products
5-41
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)
OL-4803-01
Chapter 5 Parameters and Defaults
Diagnostic Parameters
Example
If the program prserv.exe is running on a host with IP address 192.168.2.170 and listening port 9001, set
NPrintf to 192.168.2.170.9001. This causes the Cisco ATA to send all debug traces to that IP address.
Value Type
Extended IP address
Default
0
Voice Configuration Menu Access Code
81
TraceFlags
Description
This parameter is reserved in MGCP. The Cisco ATA will output all MGCP messages regardless of this
parameter value.
Value Type
Bitmap
Default
0x00000000
Voice Configuration Menu Access Code
313
SyslogIP
Description
Use this parameter for diagnostic purposes; specify the IP address and port number to which the
Cisco ATA should send its syslog output information.
The program prserv.exe, which is included in all Cisco ATA software upgrade packages, can be used to
capture syslog information if you do not have a syslog server.
Syntax
<HOST_IPaddress>.<HOST_PORT>
Example
If you want to send syslog information to the host at IP address 192.168.2.170 and port number 514, do
the following:
• Configure the value of this parameter as 192.168.2.170.514
• On your PC, run the command:
prserv 514