Cisco Systems ATA 186 Telephone User Manual


 
8-10
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)
OL-4803-01
Chapter 8 Troubleshooting
Obtaining Network Status Prior to Getting IP Connectivity
Obtaining Network Status Prior to Getting IP Connectivity
Using voice configuration menu code 3123#, you can obtain basic network status to use for diagnostic
purposes. After you enter this code, the Cisco ATA announces a message in the following format:
e123.D.0xX
where:
D is the VLAN ID (this is a non-zero value if the Cisco ATA has entered a VLAN)
0xX is a bitmap value in hexadecimal format. The definition of each bit is shown in Table 8-2.
Table 8-1 Tone Type Identifiers
Tone Type ID Description
0 Dial tone
1 Busy tone
2 Reorder tone
3 Ringback tone
4 Call-waiting tone
5 Warning or confirmation tone
6 DTMF digit 0
7 DTMF digit 1
8 DTMF digit 2
9 DTMF digit 3
10 DTMF digit 4
11 DTMF digit 5
12 DTMF digit 6
13 DTMF digit 7
14 DTMF digit 8
15 DTMF digit 9
16 DTMF digit A
17 DTMF digit B
18 DTMF digit C
19 DTMF digit D
20 DTMF digit *
21 DTMF digit #
22 CPE alert signal (for off-hook Caller ID generation)
23 Outside dial tone
24 Prompt tone
25 Beep tone