Filter
Top Products
8-12
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)
OL-4803-01
Chapter 8 Troubleshooting
Obtaining Network Status After Getting IP Connectivity
• NTP: D1,D2,D3
• tftp: 0xX
where:
–
D0 is the VLAN ID. It should be non-zero if the Cisco ATA has entered a VLAN.
–
S is the tftp filename, which can be either ata<macaddress> or the filename supplied by the
DHCP server.
–
D1 is the local time on the Cisco ATA.
–
D2 is the last NTP contact time.
–
D3 is the last successful NTP contact time.
D1, D2, D3 values are shown in number of seconds since 00:00:00 UTC, 1970-01-01. If no NTP
response has been received from the NTP server, the values of D1, D2, and D3 are 0.
–
0xX is a bitmap value in hexadecimal format. The definition of each bit is shown in Table 8-4.
Example
If the hexadecimal value provided by the web configuration menu is 0x1011, the network status of the
Cisco ATA is shown in Table 8-5.
Table 8-4 Web Configuration Menu Network Status Bitmap
Bit Number Description
0 Cisco ATA sent request for configuration file, ata<macaddress>, to TFTP server
1 Cisco ATA sent request for configuration file, atadefault.cfg, to TFTP server
4 Cisco ATA sent request for image file to TFTP server
5 Cisco ATA failed to upgrade to the downloaded image file
8 Configuration file is not found
9 Bad configuration file
10 Checksum error for configuration file
11 Decode error for configuration file (encryption related)
12 Configuration file is processed successfully
Table 8-5 Web Configuration Menu Example Network Status
Bit Number Description Boolean Value
0 Cisco ATA sent request for configuration file, ata<macaddress>, to
TFTP server
True
1 Cisco ATA sent request for configuration file, atadefault.cfg, to
TFTP server
False
4 Cisco ATA sent request for image file to TFTP server True
5 Cisco ATA failed to upgrade to the downloaded image file False
8 Configuration file is not found False
9 Bad configuration file False
10 Checksum error for configuration file False