Filter
Top Products
4-5
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)
OL-4803-01
Chapter 4 Cisco ATA-Supported MGCP Services
Complete Reference Table of all Cisco ATA MGCP Services
Syntax Type 2
RSIP *@ip_address MGCPVersion
RM: restart
Upon a successful response from the Call Agent to the RSIP command, the Cisco ATA places each
MGCP endpoint into the connected state and resumes normal operation. Destinations of subsequent
Cisco ATA commands to the Call Agent are set according to the NotifyEntity header. Call Agent
responses are always sent to the source address of the origin of the command.
If the Cisco ATA does not receive a Call Agent response to a subsequent command when the maximum
number of retransmissions of the command times out, the Cisco ATA puts both Call Agent endpoints
back into the disconnected state. The Cisco ATA then sends RSIP messages to the destinations indicated
in the NotifyEntity header. This is shown in the following example:
RSIP Message for Disconnect State
RSIP *@ip_address MGCPVersion
RM: disconnected
Complete Reference Table of all Cisco ATA MGCP Services
Table 4-1 is a reference table that lists all configurable features for the Cisco ATA (using MGCP), and
includes links to the detailed descriptions of the parameters used for configuring these features.
Table 4-1 Configurable Features and Related Parameters for MGCP
Configurable Feature Related Parameter
Caller ID format CallerIdMethod, page 5-21
Call waiting SigTimer, page 5-26
Cisco Discovery Protocol—disabling OpFlags, page 5-27
Codec—Specify default preferred codec PrfCodec, page 5-15
Codec names to use in LocalConnectionOption
command
CodecName, page 5-19
Configuration-update interval CfgInterval, page 5-5
DHCP usage—disabling DHCP, page 5-8
Debug messages—configuring host NPrintf, page 5-40
DNS name resolution OpFlags, page 5-27
Domain name server DNS1IP, page 5-10
Domain name of endpoint ID Domain, page 5-18
Dual Tone Multi-frequency (DTMF) method AudioMode, page 5-20
Encryption EncryptKey, page 5-6, EncryptKeyEx, page 5-7
Endpoint-identifier specification EPID0orSID0 and EPID1orSID1, page 5-14
(Also see the “Endpoints and Connections”
section on page 4-3.)
Fax CED tone detection
Fax CNG tone detection
AudioMode, page 5-20