Cisco Systems ATA 186 Telephone User Manual


 
2-2
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)
OL-4803-01
Chapter 2 Installing the Cisco ATA
Network Requirements
Network Requirements
The Cisco ATA acts as an endpoint in an IP telephony network. The following equipment is required:
Call Control system
Voice packet gateway—Required if you are connecting to the Public Switched Telephone Network
(PSTN).
Ethernet connection
Safety Recommendations
To ensure general safety, follow these guidelines:
Do not get this product wet or pour liquids into this device.
Do not open or disassemble this product.
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
Use only the power supply that comes with the Cisco ATA.
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Read the installation instructions before you connect the system to its power source.
Warning
The plug-socket combination must be accessible at all times because it serves as the main
disconnecting device.
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.
For translated warnings, see the Regulatory Compliance and Safety Information for the Cisco ATA 186
and Cisco ATA 188 manual.
What the Cisco ATA Package Includes
The Cisco ATA package contains the following items:
Cisco ATA 186 or Cisco ATA 188 Analog Telephone Adaptor
Read Me First - ATA Boot Load Information
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor at a Glance