Filter
Top Products
16
Ch. 3 Functions
Functions
2
Press the key for the desired character.
3
Press or until the desired accented
character or symbol is highlighted.
4
Press . The selected character is
added to the text and
Alt
mode turns off.
Enter ( )
To create a new line and move the cursor to the
beginning of it, press once you have fin-
ished entering a line of text. .
New Block ( + )
To change the number of lines in a section of
the label, create a new block by holding down
and pressing .
NOTE
☞ To display capital letters
, hold down (or
press to turn on
Caps
mode) before press-
ing a letter key.
☞ To turn off the
Alt
mode without adding a char-
acter to the text
, press (or ) at any time
NOTE
To enter a series of characters in
Alt
mode
, hold
down before pressing . Then, con-
tinue adding characters by selecting them as
explained in steps
2
and
3
, and holding down
while pressing . Press just
after selecting the last character in the series.
Shift
Caps
Cancel
Alt
uffl ë
ëéèêee
Style Italic Vertical
Caps Alt Template Zoom
B
ac
k
-
ground
H
a
lf
Cutter
36mm
24mm
18mm
12mm
9mm
6mm
1
1/2"
1"
3/4"
1/2"
3/8"
1/4"
A
uffl é
ëéèêee
Style Italic Vertical
Caps Alt Template Zoom
Back-
ground
Half
Cutter
36mm
24mm
18mm
12mm
9mm
6mm
1
1/2"
1"
3/4"
1/2"
3/8"
1/4"
A
New Block
Code
New Block
Code
New Block New Block
NOTE
A single block of text can only contain the maxi-
mum number of lines shown in the table below. If
the block already contains the maximum number of
lines when you press , the error message
“LINE LIMIT” will appear.
NOTE
☞
A single label can only contain a maximum of
five blocks. If five blocks already exist when
is held down and is pressed, the
error message “MAX 5 BLOCKS” will appear.
☞ To split a text block into two so that the charac-
ter on the right of the cursor is at the beginning
of the second block,
position the cursor in the
middle of the block, and then hold down
and press .
New Block
New Block
New Block
Tape widths
Maximum number of
lines that can be entered
1/4” (6 mm) 2
3/8” (9 mm) 3
1/2” (12 mm) 4
3/4” (18 mm) 6
1” (24 mm) 8
1 1/2” (36 mm) 10
Code
New Block
Code
New Block
Code
New Block
Code
New Block