Filter
Top Products
Local Administrative Options
68 4600 Series IP Telephone Installation Guide
2. Enter a valid Group value (0-999).
If a value different from the current Group value is entered, the following text displays
left-justified at the top of the display:
3. Press the * button to terminate the procedure, or the # button to save the new value.
If you press the # button, the following text displays:
The new value is saved and the user interface is restored to its previous state.
Interface Control
Use the following procedure to set or change the interface control value.
Note:
Note: The 4601, 4602, and 4690 Telephones do not have Ethernet PC interfaces, so
this procedure does not apply to those phones.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
faceplate of the telephone:
Mute 4 6 8 # (Mute I N T #)
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons. The 4630 and 4630SW IP Telephones do not have a dedicated
Hold button. For all other 4600 Series IP Telephones, pressing the Hold button
instead of the Mute button also works.
2. For telephones that support an Infrared (IR) interface (4620 and 4620SW only), proceed
directly to Step 7. If the telephones have an internal Ethernet switch, proceed to Step 3.
After entry of the command sequence, telephones with an internal Ethernet switch display
the following text, depending on the current interface control value:
Save new
value?
*=no #=yes
New value
being saved
PHY1=status
*=change #=OK