Filter
Top Products
Group Identifier
Issue 6 February 2007 67
3. Press the * button to terminate the procedure, or the # button to save the new values.
If you press the # button, the following text displays.
The new values are saved, and the user interface is restored to its previous state.
4. If a new value was not entered before the first time the # button was pressed, the following
text displays:
Pressing the # button ends the procedure and restores the value to its previous state.
Group Identifier
Use the following procedure to set or change the Group Identifier.
Note:
Note: Perform this procedure only if the LAN Administrator instructs you to do so.
The 4601 IP Telephone does not support the Group Identifier.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
faceplate of the telephone:
Mute 4 7 6 8 7 (Mute G R O U P)
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons. The 4630/4630SW IP Telephones and the 4690 IP Conference
Telephone do not have a dedicated Hold button. For all other 4600 Series IP
Telephones, pressing the Hold button instead of the Mute button also works.
The following text displays left-justified at the top of the display:
where ddd is the Group value.
New value
being saved
No new values?
#=OK
Group=ddd
New=_