Filter
Top Products
Visual/Audible Alerting Procedure
Issue 6 February 2007 59
5. To change the AGC Speaker value from On to Off, press 0. To change the AGC Speaker
value from Off to On, press 1.
If a value different from the current AGCHAND value and/or the current AGCHEAD value
and/or the current AGCSPKR value is entered, all telephones except the 4601 display the
following text left-justified at the top of the display:
6. Press the * button to terminate the procedure, or the # button to save the new value(s). If
you press the # button, all telephones except the 4601 display the following text:
The telephone saves the new value(s).
Visual/Audible Alerting Procedure
Use this procedure to set or change the Alerting mode. As of software Release 2.2, all 4600
Series IP Telephones can alert a user to incoming calls audibly (the default) or both audibly and
visually. Visual alert is useful in noisy environments where an audible alert might not be heard,
or to tell at a glance which of several phones is ringing.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
telephone’s faceplate:
Mute 2 5 3 7 8 # (Mute A L E R T #)
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons. The 4630/4630SW IP Telephones and the 4690 IP Conference
Telephone do not have a dedicated Hold button. For all other 4600 Series IP
Telephones, pressing the Hold button instead of the Mute button also works.
All IP telephones except the 4601 display the following text left-justified at the top of the
display:
Save new value?
*=no #=yes
New value being saved
Alerting=setting
*=change #=OK