Filter
Top Products
4600 Series IP Telephone Installation
44 4600 Series IP Telephone Installation Guide
H.323-centric SIP H.323 Perform the Mute SIG procedure to
change the SIG parameter value from
“2" (SIP) to “default” (H323). For
information, see Signaling Protocol
Identifier on page 77.
Press * to save the SIG parameter
change. Restart the telephone as
covered in Restart the Telephone
on
page 76.
Save the change & restart telephone.
SIP-centric SIP H.323 Perform the Mute SIG procedure to
change the SIG parameter value from
“default” to “1" (H323). For information,
see Signaling Protocol Identifier
on
page 77.
Press * to save the SIG parameter
change. Restart the telephone as
covered in Restart the Telephone
on
page 76.
SIP-centric H.323 in use SIP Perform the Mute SIG procedure to
change the SIG parameter value from
“1" (H323) to “default” (SIP). For
information, see Signaling Protocol
Identifier on page 77.
Press * to save the SIG parameter
change. Restart the telephone as
covered in Restart the Telephone
on
page 76.
SIP-centric H.323 factory set SIP No action is required because the
Signaling Protocol Identifier (SIG)
defaults to SIP. Upon power-up &
network connection, the telephone
automatically downloads the proper SIP
files from SES/CM.
Table 1: H.323 to SIP and SIP to H.323 Conversion Chart (continued)
Environment
To convert this
type of telephone
To this type
of telephone
Then:
2 of 2