Filter
Top Products
Operational Features
5-52 41-001129-00 Rev 09, Release 1.4.1
IP Phone Administrator Guide
Operational Features
Use the following procedure to configure the Park/Pickup call feature using the
programmable configuration method and the configuration files.
Programmable Configuration Using the Aastra Web UI
On the 480i/480i CT, you configure a Park and/or Pickup key at
Operation->Softkeys and XML. You enter a key label, and value for a specific
line on the phone. The default state of the Park configuration is "connected". The
default state of the Pickup configuration is "idle, outgoing".
The 480i CT handsets use the park/pickup configuration enabled at
Operation->Handset Keys in the Aastra Web UI. If Park or Pickup are enabled
on more than one line on the base unit, the 480i handset uses the first
programmable configuration.
For example, if line 1 and line 6 are configured for park, the 480i CT handset uses
the configuration set for line 1 to park a call.
On the 9112i/9133i, you configure a Park and/or Pickup key at
Operation->Programmable Keys, and then enter the appropriate value (and
specify a line for the 9133i).
Use the following procedure to configure the Park/Pickup call feature using the
programmable configuration method and the Aastra Web UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
“Softkey Settings for 480i and 480i CT” on page A-94 and “Programmable Key Settings for 9112i and 9133i”
on page A-100.
Note: Applicable values depend on the server in your network (Asterisk,
BroadWorks, Sylantro, ININ PBX. See the table “Park/Pickup Call
Server Configuration Values” on page 5-46.