Aastra Telecom 1000 IP Phone User Manual


 
Copyright IPitomy Communication, LLC 55 0007VRF
Filter by Type:
You can select multiple device types to filter for. Auto-Discovery is aware of MAC
address ranges used by many popular networked devices. Although this is not
the only way Auto-Discovery identifies devices, this allows the tool to identify and
filter devices by type.
Tip: Only Aastra phones are shown by default because they are set in the Filter
by Type.
Advanced Scan Settings
Changes to Scan Settings are kept when you click the GUI ‘Refresh’ button.
Clicking on your browser’s refresh button will discard changes.
The ‘Reset’ button will return all Scan Settings to original default values.
Advanced Scan Setting Description
Min Refresh Interval Minimum number of seconds required
between fresh network scans. If you
attempt to scan the network more often
than this you only get results stored from
a previous scan.
Maximum wait Maximum number of seconds to wait for
all packets to return.
Packet Count
Number of packets to send.
TX Interval Transmission interval between packets.
Only meaningful when Packet Count is
greater than 1. Minimum allowed value
is 0.2
Batch Size Divide scanning range into batch jobs.
Jobs are run sequentially. Each job will
have at most <Batch Size> pings
running in parallel at a time. The special
value 255 means run all pings as one
big job.
Network Network address with last octet reserved
for From and To range. Example:
192.168.1.x
From Start number for last octet of network
address.
To End number for last octet of network
address.
Send Wakeup ping before Survey
Ping if…
Some devices are slow to respond to the
first ping they receive but have faster
response times afterwards.