3Com 5210 Telephone User Manual


 
80 CHAPTER 4: MAINTENANCE
6 Click OK.
7 If you changed the 3Com SNMP Community Strings on the Gatekeeper, SIP
Proxy Server, or any of the Back-end Servers, you must restart the SNMP agent.
Refer to Restarting Other Entities
for more information.
To change the IP Telephony Manager community string through the command
line enter:
xtcmvfpd <target chassis IP address> [-c readcomm][-C
writecomm]
where:
readcommread only community string
writecommread/write community string
If you changed the 3Com SNMP Community Strings on the Gatekeeper, SIP
Proxy Server, or any of the Back-end Servers, you must restart the SNMP agent.
Refer to Restarting Other Entities
for more information.
For more information about this command, refer to Appendix B, Command
Line Interface.
Clearing Authorized
Access Lists
If your management station is listed in the authorized access list:
1 Open a console window for the device whose authorized access list you want
to clear.
2 From that console window, click Security, then Authorized Stations.
3 Click the IP address to be cleared from the authorized access list, and then click
Delete. Repeat this step for each entry until you have deleted all entries.
4 If you changed the authorized access list on the Gatekeeper, SIP Proxy Server,
or any of the Back-end Servers, you must restart the SNMP agent. Refer to
Restarting Other Entities
for more information.
If your management station is NOT an authorized station and you need to
clear the access list to gain management capability for a device, you must use
the User Interface on the back of the NMC. Refer to the operator’s guide or
installation manual for that device for instructions on how to use the User
Interface.