Filter
Top Products
Saving and Restoring Configurations 45
Figure 20 Restore Chassis NVRAM Dialog Box
2 Enter or select the .whb file you are restoring from and click OK.
The default directory for .nvr files is: $TCMHOME/data/nvram/.
If you are saving or restoring from the command line and you are not using the
x prefix option, progress is reported as status messages on screen. For more
information refer to Appendix B, Command Line Interface.
The Chassis Restore Progress window appears.
3 When the restore is completed click OK.
Component Save to
NVRAM
Some device components, such as modems, store their settings in their own
NVRAM and use them for power-on and reset defaults.
To save a component’s settings to NVRAM:
1 Select the component whose configuration you are saving on the IP Telephony
Manager console display.
2 Select Configuration from the IP Telephony Manager Console window.
3 Select Action/Commands from the drop-down menu.
4 Click the Card Level radio button.
5 Select Software in the Category box.
6 Select Both T1/E1 and Modem to NVRAM in the Command to Execute box.
To load a component’s NVRAM settings, issue the Restore from NVRAM
command from the same command group as the Save to NVRAM command.