Filter
Top Products
AutoResponse 123
AutoResponse The AutoResponse can be invoked by the following syntax:
tcmarsp [-E event] [-h] [target]
Where:
-E event
Specifies which event to use as the default.
The specified parameter must be a substring of one of the event descriptive
strings described below. Substrings that match at the beginning of the
descriptive string have precedence over those that match in the middle. When
there are embedded spaces in the substring, the event should be properly
quoted according to shell rules. The match is case insensitive.
If no event is specified, the GUI defaults to the entire list of AutoResponse
events.
Chassis Level Events
and Responses
The following are the events and the responses to the events from the
AutoResponse command
Events
■ PSU Voltage Out of Range
■ PSU Failed
■ Fan Failed
■ HUB Temperature Out of Range
■ Global Timer 1 Expired
■ Global Timer 2 Expired
■ Global Timer 3 Expired
■ Global Timer 4 Expired
Responses (the "(N)" notation indicates that the response requires a
parameter):
■ Generate AutoResponse SNMP Trap ID (N)
■ Delay Script Execution (N) Seconds
■ Terminate Script Execution
■ Continue If Test Passes
■ Configure Module From NMC NVRAM
■ Configure Module From NMC Factory Defaults
■ Test module
■ Reset module