Filter
Top Products
975-0593-01-01 29
Circuit Level Advanced Settings
Circuit Name
All the AC and DC relays of Freedom Sequence can be assigned a
circuit name
1
(a label) from the Xanbus SCP or XDT
2
tool. The label for
each of these relays can be up to ten alpha-numeric characters.
The benefit of labelling the relays are for customizing and ease of use.
To change the Circuit Name from the Advanced Settings screen:
1. Press the Enter button to activate the circuit setup screen for the
selected circuit.
2. Press the Enter button on the Circuit Name field.
3. Press the Func button to erase the characters one by one, except the last
character. Erasing all characters will put you back to step 2.
4. Use the arrow buttons to scroll through the character set.
5. Press the Enter button to confirm a character selection. Repeat 4 and 5
to form a new circuit name, up to ten characters.
6. Press the Enter button again on the last character to confirm the new
circuit label.
NOTE: This setting can only be modified when Desired Mode is set to
Standby.
1.Circuit names can be up to ten characters long. Valid characters are from a to z, A to Z, 0 to 9,
symbols '/' (forward slash) and '-'(hyphen). Spaces, underscore and period are not accepted symbols.
2.The XDT tool is available for OEMs only.
Relay ID Default Circuit Name Possible New Name
Circuit1 ACLoad1 Main-A/C
Circuit2 ACLoad2 Space-heat
Circuit3 ACLoad3 Dishwasher
Circuit4 ACLoad4 Refrigerat
Circuit5 ACLoad5 H2O-Heater
Circuit6 ACLoad6 WallOutlet
Circuit7 DCLoad1 Thermostat
Circuit8 DCLoad2 and so on...
Circuit9 DCLoad3
Circuit10 DCLoad4
FSPM 00: Circuit 3
Circuit Name
Over-ride
Type
Line Association
[ACLoad3]
[Disabled]
[ACInputOut]
[Line1]
FSPM 00: Circuit 3
Circuit Name
Over-ride
Type
Line Association
[ACLoad2]
[Disabled]
[ACInputOut]
[Line1]
FSPM 00: Advanced Settings
Circuit1
Circuit2
Circuit3
Circuit4
FSPM 00: Circuit 3
Circuit Name
Over-ride
Type
Line Association
[D]
[Disabled]
[ACInputOut]
[Line1]
FSPM 00: Circuit 3
Circuit Name
Over-ride
Type
Line Association
[Dishwasher]
[Disabled]
[ACInputOut]
[Line1]
FSPM 00: Circuit 3
Circuit Name
Over-ride
Type
Line Association
[Dishwasher]
[Disabled]
[ACInputOut]
[Line1]
1
2
3
4
5
6
FSequence IPM Owners Guide.book Page 29 Thursday, October 6, 2011 3:33 PM