Filter
Top Products
975-0593-01-01 13
Basic Configuration Settings
Mode
The Freedom Sequence operates in two modes: Operating or Standby.
When set to Operating mode, Freedom Sequence performs the normal
function of controlling the AC and DC loads on the system. In this mode,
all the status information of the Freedom Sequence can be accessed via the
Xanbus System Control Panel (SCP) and a limited number of configuration
settings can be changed as shown in “Freedom Sequence Basic
Configuration Screen” on page 11.
Freedom Sequence can be set to Standby mode to stop it from controlling
the AC and DC loads on the system. When this mode is selected, Freedom
Sequence allows accessibility to change all the configuration on the
Freedom Sequence, including restoring to OEM default settings
1
.
When Freedom Sequence is first powered up, it will start operation in
Operating mode.
To change the Mode from the Device Status screen:
1.OEM default settings (the “OEM Profile”) are programmed by the Original Equipment Manufac-
turer. The OEM profile is available and can be accessed and modified via the XDT only.
FSPM 00: Status
L2 Amps
Batt Voltage
Circuit Status
Config
On 0.0A
12.8V
FSPM 00: Config
Mode
SHR BKR Mode
SHR BKR Rating
Circuit Config
[Operating]
[Auto]
[30.0A]
FSPM 00: Config
Mode
SHR BKR Mode
SHR BKR Rating
Circuit Config
[Standby]
[Auto]
[30.0A]
FSPM 00: Config
Mode
SHR BKR Mode
SHR BKR Rating
Circuit Config
[*Operating]
[Auto]
[30.0A]
FSPM 00: Config
Mode
SHR BKR Mode
SHR BKR Rating
Circuit Config
[Standby]
[Auto]
[30.0A]
1 Press down until the
field is selected.
3 Press to change
the setting.
4 Press to select a
new value.
5 Press to confirm
the new value.
2 Press to select
Config.
FSequence IPM Owners Guide.book Page 13 Thursday, October 6, 2011 3:33 PM