Filter
Top Products
Additional Information
User's Manual 12-3
TOSHIBA Pocket PC e740 Version
1
Last Saved on 10/05/2002 21:02
ENGLISH using Euro_C.dot –– Printed on 10/05/2002 as PDA3_UK
Symptom Cause Correction
The Battery power is too
low to use USB devices.
Charge the battery or connect
AC adapter.
Following message is
displayed:
“Not Enough Battery
Power. There is not
enough battery power
to use USB Device”
The total power
consumption of
connected USB devices is
too large.
This USB port supports total
500mA USB device. Confirm
connected USB device.
Following message is
displayed:
“USB OVER CURRENT
DETECT USB device is
turned off. Please
disconnect USB
device.”
The total power
consumption of
connected USB devices is
too large.
This USB port supports total
500mA USB device. Confirm
connected USB device.
To enable USB port again, turn
off the power of Pocket PC and
push Reset Switch.
Symptom Solutions
Cannot connect to the
network
■ Make sure the Wireless Communication Switch is
turned on.
■ Check if the SSID is correct (note that it is case-
sensitive)
■ Check Link Quality in Configuration Page. If the link
quality is poor, rescan and find another Access Point.
■ Check if the operating mode is set properly. See
Chapter 4, Configuration Page.
■ Check if the WEP key is correctly entered.
■ Be sure you are in the range of a working Access
Point.
■ Make sure the channel been set is in the range of
1~11.
The host computer cannot
wirelessly connect with my
Pocket PC?
■ Make sure you have setup the partnership for your
Pocket PC and your host computer.
■ Make sure you are within the range of a working
network.
■ Make sure you have entered the IP address of the
host computer as the WINS server on your Pocket
PC.
■ Reset your Handheld PC or Pocket PC to make the
TCP/IP settings take effect.
■ Make sure the SSID, WEP keys and channel for all
devices in the network are set the same.
■ Make sure the channel been set is in the range of
1~11.