Filter
Top Products
Introduction
TOSHIBA Pocket PC e740 x
TOSHIBA Pocket PC e740 Version
1
Last Saved on 10/05/2002 21:02
ENGLISH using Euro_C.dot –– Printed on 10/05/2002 as PDA3_UK
Working environment
This product was designed to fulfill the EMC (electromagnetic
compatibility) requirements for “residential, commercial and light industry
environments”.
Toshiba does not approve the use of this product in working
environments other than “residential, commercial and light industry
environments”.
For example, the following environments are not approved:
■ Industrial Environments (environments with a mainvoltage >230V~)
■ Medical Environments
■ Automotive Environments
■ Aircraft Environments
Any consequences resulting from the use of this product in working
environments that are not approved are not the responsibility of Toshiba
Corporation. The consequences of the use of this product in non-
approved working environments may be:
■ Interference with other devices or machines in the nearby surrounding
area
■ Malfunction of, or data loss from, this product caused by disturbances
generated by other devices or machines in the nearby surrounding
area
Therefore Toshiba strongly recommends that the electromagnetic
compatibility of this product be suitably tested in all non-approved
working environments before use. In the case of automobiles or aircraft,
the manufacturer or airline respectively should be asked for permission
before use of this product.
Furthermore, for general safety reasons, the use of this product in
environments with explosive atmospheres is not permitted.
CE compliance
This product and the original options are designed to observe the related
EMC (Electromagnetic compatibility) and safety standards. However,
Toshiba cannot guarantee that this product still observes these EMC
standards if options or cables not produced by Toshiba are connected or
implemented. In this case, the persons who have connected /
implemented those options / cables have to make sure that the system
(PC plus options / cables) still fulfils the required standards. To avoid
general EMC problems, the following advice should be observed:
■ Only CE marked options should be connected / implemented
■ Only best shielded cables should be connected